2003 Chevy Silverado Security System Reset. • the ctd system portion of the bcm controls the security telltale when the ignition switch is. Turn the key to on and attempt to start the engine and release the key to the on position.
Wait 10 minutes until it turns off. Mike e december 28, 2020. The directions are the same for either system (passlock has a resister in the ignition switch, passkey has it in the key).
Leave the car with the ignition. Fully push and release the accelerator pedal 3 times within 5 seconds. Web if replacing a theft deterrent control module with a gm spo replacement part, perform the procedure to setup a new theft deterrent control module prior to the 30.
Web to reset your 2002 chevy silverado security system put the key in the ignition, turn the key to the on position, and leave it on until the security light goes out. Web the relearn procedure for resetting the gm passlock or passkey security system is fairly straightforward, though it’s a little time consuming. Make sure the battery if fully charged because this procedure may take.
Web method 01 method 02 steps to reset the silverado antitheft system from the outside method 01 method 02 call an auto locksmith or repair shop how much does it cost to. Web turn the ignition key to the run position. Posted by gaylehoward on nov 17, 2009.
Try this 10 minute fix! Web we offer an extensive collection of chevy silverado security systems that will protect your property. Web web resetting the 2003 chevrolet silverado security system is easy, and takes about 5 to 10 minutes.
I can take ground on battery lose and wiggle it and can hear the clicking of the computers,. Turn the key to on and attempt to start the engine and release the key to the on position. Mike e december 28, 2020.
